튜토리얼&예제 Strand7 콘크리트 거푸집 구조물 열전달 해석
페이지 정보
본문
Bricks and Heat – Pre-cast Concrete Test Block
Outcomes
Upon successful completion of this lesson you will be able to:
1. Build a simple brick model.
2. Use the Transient Heat solver.
3. Enter information into a Factor vs Time table.
4. Assign thermal properties and attributes to elements.
5. Use the Heat Source attribute.
6. Use the cutting plane for inspecting results
7. Understand how to run a static analysis using the results of the transient heat solution.
8. Understand how to run a transient dynamic analysis using the results of the transient heat solution
as the thermal load.
Introduction
In this model the Transient Heat solver is used to determine the temperature distribution over time,
due to internal heat generated by the concrete curing reactions.
The model is a test block for a floating concrete platform. It will be built from brick elements using
manual meshing tools in Strand7.
Problem
The model is a square concrete block with a circular
cavity in the centre. The block has formwork around
the outside and also as lining within the cavity.
The dimensions of the model are:
• Block is 2 m square and 1 m high.
• The hole has a diameter of 1.5 m and a depth of 0.75 m.
• All of the timber formwork is 50 mm thick.
The material properties are:
• Concrete - Strength Grade 32 MPa.
• Formwork - Timber (Green) Pine Maritime.
첨부파일
-
brick_heat.zip (428.9K)
0회 다운로드 | DATE : 2021-02-01 15:58:15
- 이전글Guard Rail Impact Analysis - Beam Model 21.02.01
- 다음글매스콘크리트 수화열해석 21.02.01
댓글목록
등록된 댓글이 없습니다.